Deleting all taught/stored User Keys
1 Condition: Taught/stored User Keys in memory.
2 Insert Master Key into ignition switch and turn it
to running position (position 1).
3 Wait 20 seconds.
→ All User Keys are deleted.
5. Hydraulic Lock switch (optional)
When installed, after starting procedure with locking
console in vertical position (read instruction in
chapter
Starting engine
, page
74
), also the
hydraulic lock switch must be pressed to open the
hydraulic circuit.
Locking console in vertical position.
Press hydraulic lock switch.
→ Hydraulic lock switch illuminates.
→ Machine can be operated (Hydraulic is
unlocked).
If machine is equipped with a Seat Sensor, the
hydraulic stops when getting up from seat.
→ To enable hydraulic back, sit down and press
hydraulic lock switch.
6. Switch for working lights
Press lower end of switch = working lights are off
Switch in middle position = front working lights are
on
Press upper end of switch = front working lights,
rear working light (optional equipment) and
working light on boom (optional equipment) are
on
NOTE!
The working lights can only be switched on if the
ignition has been activated (running position/
position 1).
7. Switch for variable tracks
(not for EC15E)
Activate this switch and the track can be adjusted
via the dozer blade control lever (see page
45
)
To Next Page
Loading...
