||
08 Starting and driving
08
262
* Option/accessory, for more information, see Introduction.
3. Fold up the nozzle (1), take a deep breath
and blow with an even pressure until a
"click" is heard after approx. 5 seconds.
The result will be one of the alternatives in
the following table Result after breath
test.
4. If no message is shown then the trans-
mission to the car may have failed - in
which case, press the button (3) to trans-
mit the result to the car manually.
5. Fold down the nozzle and refit the alcohol
lock in its holder.
6. Start the engine following an approved
breath test within 5 minutes - otherwise it
must be repeated.
Result after breath test
Indicator lamp
(5) + Display
text
Specification
Green lamp +
Alcoguard
Approved test
Start the engine - no
alcohol content meas-
ured.
Yellow lamp +
Alcoguard
Approved test
Engine starting possi-
ble - measured alcohol
content is above
0.1 promille but below
the limit value in
force
A
.
Red lamp + Dis-
approved test
Wait 1 minute
to try again
Engine starting not
possible - measured
alcohol content is
above the limit value in
force
A
.
A
Limit values vary from country to country. Find out what
applies in your country. See also Alcohol lock* - to bear in
mind (p. 263).
NOTE
After a completed period of driving, the
engine can be restarted within 30 minutes
without a new breath test.
Related information
•
Alcohol lock* (p. 260)
•
Alcohol lock* - functions and operation
(p. 260)
•
Alcohol lock* - storage (p. 261)
•
Alcohol lock* - to bear in mind (p. 263)
•
Alcohol lock* - symbols and messages
(p. 264)
To Next Page
Loading...
