EasyManuals Logo

Von Duprin 376-T User Manual

Von Duprin 376-T
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
*941148-00*
941148-00
Corresponds to
center line of
Thumbturn
11/16” R, 2 places
(omit for BE)
1/2” dia.
2 places
6-1/4
Outside
face of
lock stile
Inside
face of
lock stile
LHR shown
RHR opposite
5/16” dia.
2 places
3
7/16
1-7/8
1. Prepare door for exit device. See exit
device instructions for locations of
holes, backset (line X-X), and center
lines.
2. Prepare door for control:
A. Transfer line X-X from inside (exit
device side) of door to outside
(control side) of door. Use extra
care if edge of door is beveled.
Be sure line X-X is parallel to edge
of door.
B. Locate and prepare holes as
indicated.
3. Reverse cam on back of control if reqd.
(see Figure 1 on backside of sheet).
4. Install rod member (Figure 2):
A. Slip top rod assembly in door until
bottom of rod is visible in control
cutout.
B. Slip rod member on top rod
according to handing of door. Keep
rod member visible in cutout and
lower top rod assembly until latch
release is in position on latch release
reinforcement. Slightly tighten socket
set screws in rod member to
maintain this position.
C. Install and adjust top and bottom rod
assemblies. See installation
instructions for vertical rod device.
D. Adjust member so that the bottom
surface is 1/8” below the centerline
of thumbturn. Secure rod member
by tightening socket set screws.
5. Complete the device installation.
6. Install cylinder if required (Figs. 3 & 4).
Insure cylinder cam is set for required
function
and replace if necessary.
7. Retract latch bolts by depressing
device crossbar.
8. Apply control and test key, control,
and device action.
1-3/8” dia.
(BE only)
Omit cylinder
for BE function
For cutouts on inside face
of door see instructions in
device carton
Device Application Schedule
5547-F Vertical Rod Exit Device
8847-F Vertical Rod Exit Device
1/4
53-1/2
to finished
floor
C
L
C
L
C
L
C
L
of vertical rod
of control
of vertical rod
Control for Metal Door Application
376-T, 376-T-BE
Installation Instructions
© Allegion 2014
Printed in U.S.A.
941148-00 Rev. 01/14-b
Customer Service
1-877-671-7011 www.allegion.com/us

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Von Duprin 376-T and is the answer not in the manual?

Von Duprin 376-T Specifications

General IconGeneral
BrandVon Duprin
Model376-T
CategoryDoor locks
LanguageEnglish

Related product manuals