EasyManuals Logo

Vonyx VXA Series User Manual

Vonyx VXA Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
FRONT PANEL
1. On/Off Switch.
For switching the amplifier on and off. Always adjust the volume down to its minimum before switching this
amplifier on.
2. Cooling Vents.
Front to rear forced airflow.
3. Volume Controls.
These controls adjust the volume level of both channels. Turn slightly to the left when the clip indicators (4)
light up.
4. Signal indicators.
Three orange LEDs indicate the amplifiers output signal levels.
5. Clip Indication.
These LEDs will light up when one or both channels are on max power. It can occur that these LEDs will lit up
now and then, this is not a problem. But if it lights up continually you need to adjust the volume down,
otherwise permanent damage to equipment might occur
6. Protect Indication.
When on any given point, something damaging might occur to your amplifier, it will switch in protect mode.
The amplifier will disconnect the point where the damage is about to occur and switch on the protection led to
indicate to you that something is wrong. Reasons might be: Bad ventilation,
A low impedance (< 4 Ohm), Defect fan(s), A short circuit in cables.
7. Bridge Mode Indication.
8. Power Indication.
This clear blue indicator will light when the amplifier is turned on.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vonyx VXA Series and is the answer not in the manual?

Vonyx VXA Series Specifications

General IconGeneral
Power OutputCheck specific model within VXA Series
Frequency ResponseCheck specific model within VXA Series
Input SensitivityCheck specific model within VXA Series
Signal to Noise RatioCheck specific model within VXA Series
Total Harmonic DistortionCheck specific model within VXA Series
Input ConnectionsCheck specific model within VXA Series
Output ConnectionsCheck specific model within VXA Series
CoolingCheck specific model within VXA Series
ImpedanceCheck specific model within VXA Series
Input ImpedanceCheck specific model within VXA Series
Power SupplyCheck specific model within VXA Series
Damping FactorCheck specific model within VXA Series
DimensionsCheck specific model within VXA Series
WeightCheck specific model within VXA Series

Related product manuals