What to do if Vonyx Microphone sound level differs from a cabled instrument?
If the receiver signal indicators A/B lights are glowing, adjust the transmitter gain level to compensate and adjust the receiver volume as needed.
What causes bursts of noise in my Vonyx Microphone?
Bursts of noise or audible radio signals may be present if signal indicators A/B lights are on. Identify any potential sources of interference (like other RF-sources) and either turn them off, remove them, or switch to a wireless system that operates on a different frequency.
Why does the distortion level increase gradually on my Vonyx Microphone?
If the receiver signal indicators A/B lights and the transmitter LOW BATTERY light are glowing, replace the transmitter battery.
What to do if there is momentary loss of sound when moving Vonyx Microphone?
If the receiver signal indicator A/B lights go off when the sound is lost, reposition the receiver and perform another walk-through test. If audio dropouts continue, identify these 'dead' spots and avoid them during your performance.
Why is there no sound coming from my Vonyx Microphone?
There could be several reasons for the lack of sound: * If the red transmitter indicator is not flashing, ensure the transmitter POWER ON/OFF switch is in the ON position. Also, check the battery is correctly inserted, respecting the (+ / -) polarity. If it is, try replacing it with a new battery. * If the red transmitter indicator is flashing, ensure the transmitter MUTE/ON switch is in the ON position. * If the red receiver indicator POWER light is off, verify the AC adapter is securely connected to both the electrical outlet and the DC input connector. Confirm the outlet is working and providing the correct voltage. * If the receiver signal indicators A/B lights are glowing, increase the receiver volume. Also, check that the output connections from the receiver to the external...
General| Brand | Vonyx |
|---|---|
| Model | WM511 |
| Category | Microphone system |
| Language | English |
To Next Page
