Voodoo Lab PEDAL POWER 2 User Manual

VOODOO LAB PEDAL POWER
User’s Manual
Introduction
The Voodoo Lab Pedal Power is the finest power supply available
for pedal effects. The Pedal Power provides eight 9V outputs which
will power any type of battery operated effects. Each output is com-
pletely isolated, short-circuit protected, highly filtered and regulated.
This insures reliable operation, free of hum and noise.
The new Pedal Power 2 will also power Line6 modeling pedals and
includes two variable voltage outputs to simulate worn batteries.
Please take the time to read this entire manual before operating
your Voodoo Lab Pedal Power. This will eliminate the possibility
of damage to your effects from improper usage. You can also visit
our web site at www.voodoolab.com for the latest information on
this and other products.
Unpacking
Your Voodoo Lab Pedal Power box should contain the following:
Pedal Power 2 system unit
Warranty card
AC power cord
DC Power cables:
5.5x2.1mm barrel connectors (6)
5.5x2.5mm “red” barrel (1)
3.5mm mini plug (1)
9V battery snap (1)
Please take a moment to fill out and mail your warranty card. This
will register your warranty, make you eligible for technical support,
and allow us to notify you with updates and new product information.

Voodoo Lab PEDAL POWER 2 Specifications

General

Total Outputs	8
Transformer	Yes
Isolation	Fully isolated outputs
Input Frequency	50/60 Hz
Output Voltage	9V DC
Output Current	100mA
Dimensions	6 x 3.4 x 1.75 inches
Weight	2 lbs
Input Voltage	120V AC