7
English
6 English
- Before moving, repositioning, servicing, cleaning and when not in use, use
the product controls to turn off the power and then unplug. To disconnect
from outlet, grasp and pull only the plug. Also, power off and unplug if the
product will be left unattended for an extended period of time or during
electrical storms.
SERVICING WARNING—To reduce risk of re, electrical shock and
injury to persons, observe the following:
- Clean your product regularly, only as is instructed in this manual. Prior
to cleaning, turn off the power on your product and unplug. Do not use
gasoline, thinners, solvents, ammonias or other chemicals for cleaning.
Refer to the CLEANING instructions provided.
- Do not open appliance housing while product is plugged in. To avoid risk
of shock, all service and/or repairs must be done by a Vornado Authorized
Service Center.
- Risk of re. Do not replace attachment plug.
FCC Compliance Statement
NOTE: This equipment has been tested and complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
- Do not operate unit if the unit has been dropped or damaged. Do
not use this product if it has a damaged cord or plug. To avoid risk of
electrical shock, do not attempt to repair or replace parts. Only original
replacement parts may be used. If the power cord is damaged, it must
be replaced by the manufacturer, its service agent, or similarly qualied
persons in order to avoid a hazard. Contact Vornado Consumer Service
at 1-800-234-0604 (phone) or consumerservice@vornado.com (email) for
further instructions about replacement and repair.
- Risk of re. Your appliance is equipped with a detachable power supply.
The detachable external power supply (DZ018CHL120150U) and cord have
no user replaceable parts. If the power supply or cord is damaged, it must
be replaced by the manufacturer or its service agent or a similarly qualied
person in order to avoid a hazard. Use only the detachable external power
supply and cord that comes with your product.
- Before plugging power cord into electrical outlet, be sure that all
electrical information on the rating label, including voltage, is compatible
with your outlet’s power supply.
- Do not sit or stand on product.
- Never use the cord as a handle or otherwise yank, strain or stretch the
power cord.
- While the product is plugged in, do not insert or allow foreign objects to
enter any input or output opening as this may cause risk of electric shock
or re, or damage the product.
- A loose t between wall outlet (receptacle) and plug may cause
overheating and distortion of the plug. Discontinue use of the product in
this outlet. Contact a qualied electrician to replace loose or worn outlets.
To Next Page
Loading...
Need help?
General