13
English
HOW TO USE
1. Insert power cord plug into port
that extends from the bottom of the
product. Plug the power cord into a
power outlet.
2. Touch ( ) to power ON or OFF. Your
circulator returns to last saved memory
setting.
3. Select desired speed by pressing -/+.
Speed is indicated by number of white
LEDS as shown on the display.
4. Double tap at any area along the
control panel perimeter for targeted
airow. The airow will then point
where directed.
Want to see a demonstration? Scan here.
SPEED 2
SPEED 1
SPEED 3
SPEED 4
To Next Page
Loading...
