11
English
10 English
1. Plug the unit in, but do not press
to turn product on.
2. Remove pull tab completely from the remote.
3. Press on the unit.
4. Press and hold on remote for 3 seconds.
5. Your remote is now paired.
1. Press
to power on/off.
2. Select desired fan speed setting by pressing or .
3.
Press to turn Oscillation on/off. Press and hold
for three seconds to change oscillation angle to 180°.
REMOTE CONTROL
REMOTE FUNCTIONS BATTERY REPLACEMENT
REMOTE SETUP
1. For battery replacement, the remote requires one coin style 3V
CR2032 battery. Always use the correct size and grade of battery for
this product.
2. To replace battery, open battery door on the back side of the
remote control (you will need to loosen the small screw on door
using a #1 Phillips screwdriver). If necessary, clean the battery
contacts and also those of the device prior to battery installation.
Remove any plastic protection from the battery and place it
in the remote with the + side facing out. Ensure the battery is
installed correctly with regard to polarity. Replace the battery door
and screw.
Note: Remove battery from the remote control when not in use for an
extended period of time and always remove dead battery immediately
and replace with fresh. Do not store dead battery in remote.
Your remote includes (1) coin style 3V CR2032 battery. Battery comes
pre-installed. Remove battery pull tab before rst use. Pre-installed
battery has a one-year life expectancy (dependent on use) after pull
tab has been removed from remote.
The remote that comes with your unit is paired and ready to use out
of the box. If you need to pair a remote, follow these steps:
WARNING: This product contains a button battery. If swallowed,
it could cause severe injury or death in just 2 hours. Seek medical
attention immediately.
HOW TO USE
OSCILLATION
POWER ON/OFF
GREEN LED LIGHT
SPEED ADJUSTMENT
/
1. Touch to power on/off. When unit is powered
ON, the green LED will illuminate.
2. Select desired fan speed by pressing to
increase fan speed or to decrease fan speed.
Speeds are Low, Medium Low, Medium,
Medium High and High.
3. Press
to turn Oscillation on/off. The default
oscillation range is 90°. To activate 180°
oscillation range, press and hold oscillation
button for 3 seconds. The green LED will ash
when oscillation angle has successfully been
changed.
Note: After unit is unplugged and then plugged
in again, the unit will oscillate until it locates its
“default” position centered between the two front
legs.
OSCILLATION
POWER ON/OFF
SPEED ADJUSTMENT /
To Next Page
Loading...
