Need help?Do you have a question about the VOTEC 322 and is the answer not in the manual?
Plane is not a toy; keep away from children under 16. Read manual before use.
Gather rudder, rudder angles, tie rods, and rockers for wing servos.
Roughen rudder angle surface for better AB glue adhesion.
Install rudder, fix with screws, attach rocker arm, adjust tie rods.
Visual example of completed rudder assembly with tie rods and servos.
Gather rudder, rudder horns, tie rods, and rocker arms for the flat tail.
Roughen rudder horn surface for improved AB glue bonding.
Install rudder, fix with screws, attach rocker arm, adjust tie rods.
Example showing completed flat tail servo installation with components.
Gather rudder, rudder horns, tie rods, and rocker arm for the rudder.
Roughen rudder horn surface for enhanced AB glue adhesion.
Install rudder, fix with screws, attach rocker arm, adjust tie rods.
Final look at the completed rudder servo assembly.
Gather rudder, connecting rod, and fixing screws for installation.
Align rudder, insert connecting rod through the top hole.
Insert spacer, tighten fixing screws to secure the rudder.
Gather tail wheel, screws, and other necessary parts.
Screw the tailwheel to the bottom of the wing using pre-cut holes.
Make holes in the flat tail and snap springs to the tail wheel and catches.
Gather landing gear components, wheels, and screws.
Install the axle onto the main landing gear structure first.
Mount wheels on the axle, secure with screws, and attach wheel covers.
Screw the fixed flat-tail into the fuselage holes as shown.
Insert carbon fiber tube and connect servo link cable to fuselage extension.
Push the screw up to the fixed position and tighten it to secure the flat tail.
Thread the carbon fiber tube through the pre-drilled holes in the fuselage.
Place wing onto tube, attach rudder connector to fuselage through reserved hole.
Apply glue to screws, insert, and tighten screws to fix the wing securely.
Align wing fixing screws with the fuselage's quick release holes.
Push forward snap before inserting screws, then loosen clips to secure.
Mount the engine onto the designated frame within the fuselage.
Mount and connect the throttle servo to the engine control linkage.
Position the cowl, align it, and fasten it with screws.
Flip the body, drill bottom holes for the cowl, proofreading position first.
Specifies the engine opening position for the GP76 engine model.
Align cockpit to fuselage position with circles pointing backward; push snap buttons.
Push the cockpit down into its final secured position.
Place the receiver in the designated mounting position within the fuselage frame.
Gather wingtips and mounting screws for installation.
Insert screws into mounting holes, align wing holes, and tighten.
CG is at the leading edge of the wing 145mm, and 65mm from the wingtip leading edge.
Provides address, phone number, email, and website for Dong Guan Flight Aviation Technology.
To Next Page
General