To Next Page

To Previous Page

3. [GUITAR] connector

Plug in your guitar (or other acoustic musical instrument featuring a pick-up) using a high-quality

shielded cable.

NOTE:If you plug in your instrument to this connector, the [MIC] connector on the same channel will

be disabled.

4. [GAIN] switch

Set the input gain to “LOW” or “HIGH” depending on the volume level of the musical instrument

connected to the [GUITAR] or [MIC] connector.

5. [MIC] connector

Connect your microphone to this balanced XLR connector.

6. [PHANTOM] switch

Turn this switch on when you connect a condenser microphone that requires phantom power. When

the phantom power is being supplied, the indicator above the switch lights up.

NOTE:If the microphone does not require phantom power, turn the [PHANTOM] switch off.

NOTE:Before you turn the [PHANTOM] switch on or off, be sure to set the [MASTER] volume control

to minimum. Also, before you connect a microphone to the [MIC] connector, be sure to turn the

[PHANTOM] switch off.

7. [VOLUME] control

This control knob enables you to adjust the volume level of the musical instrument connected to the

[GUITAR] or [MIC] connector. Use this control on each channel to adjust the level and balance be-

tween the Normal and Tube Pre channels.

Vox AGA150 User Manual

Questions and Answers: