9
16. [ALL MUTE] switch
Set this switch to On to mute the sound output from the amplifier.
NOTE:This switch does not mute the sound output from the [DI OUT] or [TUNER OUT] connectors.
HINT: Connect an optional VFS2 dual foot switch to the amplifier to control All Mute on and off with
your foot.
17. [ANTI-FEEDBACK] control
This control enables you to reduce the amount of feedback that is caused when the output from the
amplifier is picked up via a guitar or microphone.
Set the control knob so that the amount of feedback will be minimum.
Turning the control knob clockwise will move the cut point to a higher frequency range. Turning the
control knob counter-clockwise all the way will turn off the anti-feedback effect.
Turn this control off if you hear no feedback.
18. [POWER] indicator
The indicator lights up when the power to the unit is turned on. The [POWER] switch is located on the
rear panel.
To Next Page
Loading...
Need help?
General
