10 APS997Z Owners REV.B
Using the “Quick-stop” Feature (Optional)
If you want to make a short stop and keep your vehicle running (to keep
the interior warm or cool), the quick-stop feature allows you to do this while
keeping your vehicle secure and your keys with you.
To engage Quick Stop:
1. Stop the vehicle and place the transmission in PARK.
2. With your foot o the brake pedal, press and release the button
two (2) times within 2 seconds. The LED will ash three (3) times to
conrm quick stop is entered.
3. Remove the keys from the ignition and exit the vehicle. Press the
button to lock the vehicle’s doors if desired.
To engage Quick Stop - Manual Transmission Vehicles:
1. With the vehicle running, foot o the brake, parking brake set ON.
2. Press and release the button to activate remote start.
3. Exit the vehicle close all doors (Door Open/All Doors Close)
4. Press and release the button.
5. Within 3 seconds press the button:
The unit enters Quick Stop Mode and will remain running until remote start
time-out and then shut down. (Remote Start Ready Mode is NOT active)
Note: Do not leave children or animals unattended in the vehicle when using
the quick-stop feature.
Remote Start Service Mode
For safety, the remote star feature can be disabled to prevent accidental
starting while the vehicle is being serviced.
To engage Remote Start Service Mode
1. Press and hold the valet button.
2. Cycle the vehicle’s ignition ON/OFF three (3) times.
3. Release the valet button.
The LED will begin to ash two (2) short ashes followed by one (1) long ash
to indicate Remote Start Service Mode is active. Repeat steps 1-3 above to
disengage Service Mode.
To Next Page
Loading...
