Voxx Electronics Prestige APS997Z - Remote Start Safety Features; Remote Start Ready Mode for Manual Transmission

8 APS997Z Owners REV.B
Remote Start Ready Mode - Manual Transmission Vehicles Only
To activate the remote start function, the system must rst be in Remote
Start Ready Mode. Follow the steps below to enter remote start ready
mode.
• While the engine is running by the ignition key;
1. Place the transmission in neutral.
2. Set the parking brake.
• With your foot o󰀨 the brake pedal;
1. Press and release the button to activate the remote start.
The parking lights will turn on to conrm the system has
remote started.
2. Remove the keys from the ignition, the vehicle will remain
running.
3. Exit the vehicle and close all vehicle doors.
4. Within two (2) minutes of step 1, press the button to lock
the vehicle’s doors.
The vehicle will shutdown and sound two (2) short chirps then one (1) long
chirp to conrm ready mode is set.
Remote Start Ready Mode must be enabled if your vehicle is equipped
with a manual transmission.
Remote Start Safety Features
For safety and security reasons, the system will shutdown or prevent the
remote vehicle starter from activating if any of the following occur:
• The vehicle’s hood is open.
• The brake pedal is pressed prior to turning the ignition key to the
ON position.
• The engine is over-revved (tach checking only).
• Valet Mode is active. Refer to the Valet Mode section of this
manual on page 5.
• Remote Start Ready Mode is not set. Manual transmission
vehicle’s only.