34 Trail Tech Voyager
Vehicle Sensors:
The Vehicle Sensors settings control sensor
logging behaviors.
Menu » Set Menu
Voyager defaults to “ENG or WHL” so that Accumulated
Run Time (the total time the vehicle has been running)
only increments when the wheel is rolling or the engine
is turned on. You can change it to increment when GPS
thinks it is moving. Over time this will cause inaccuracy
due to GPS signal wander. ART will not increment if
Voyager falls into sleep mode. By default, this will not
happen because wheel and engine activity will keep
Voyager awake.
Vehicle Sensors > Accumulated Run Time:
This setting is critical for proper operation of
the wheel sensor. See the measure wheel size
section for more information.
Vehicle Sensors > Wheel Size:
Defaults:
Motorcycle: 2110mm
ATV: 1675mm
Enables or Disables wheel sensor for logging.
Vehicle Sensors > Wheel Sensor:
Enables or Disables engine sensor for logging.
Vehicle Sensors > Engine Sensor:
This is the amount of time the spark plug res per engine
revolution.
Vehicle Sensors > PPR (Pulses Per Revolution):
Sensitivity for Voyager unit reading the pulses
from the spark plug.
Vehicle Sensors > Sensitivity
Speed and distance data pull location.
Vehicle Sensors > Speed/Dist
To Next Page
Loading...
General