Safety Instructions
Read and follow the Safety Instructions below and remember to save all packing material. The
HW-40 and all VPI products should only be moved/shipped in original packaging to ensure the
product’s safety. Also, be sure to place the table and components on a flat, level surface for
easier setup.
The following instructions are to reduce risk of electrical hazard or injury.
• To avoid electrical shock/hazard, do not open remove the bottom panel.
• If the power cord provided with the HW-40 does not reach an outlet, use a heavy-duty,
grounded extension cord.
• To avoid electrical shock, always plug the HW-40 into a grounded (three prong) outlet.
• Do not expose the HW-40 to rain or excessive moisture.
• Do not turn your HW-40 motor on/off at high volumes. To be safe, it is always good practice
to mute your system before turning any motor or electrical component on or off.
• Your 3D arm is heat resistant and UV Light resistant, however it is still not recommended to
leave your arm in extremely hot environments.
Minimum Specifications
▪ Chassis Composition: Aluminum, and Walnut
▪ Platter Type & Size: 12" Aluminum, 29lbs
▪ Tonearm Included: JMW Fatboy Gimbal Limited Edition
▪ Wow and Flutter: <.008%
▪ Speed Accuracy: .01%
▪ Power Consumption: 30W pk
▪ Footprint: 21 ¾” X16 ¾”
(55.24 X 42.54mm)
▪ Overall Size: 22” X 17” X 10”
(55.88 X 43.18 X 25.4mm)
▪ Total Weight: 70lbs
To Next Page
Loading...
