Need help?Do you have a question about the VPI Classic 1 and is the answer not in the manual?
General| Platter | Aluminum |
|---|---|
| Drive System | Belt Drive |
| Wow and Flutter | 0.1% |
| Motor Type | AC synchronous |
| Type | Belt Drive |
| Speed | 33 1/3 RPM, 45 RPM |
| Motor | AC synchronous |
| Speed Accuracy | ±0.1% |
Instructions for mounting cartridges with threaded or pass-through holes, using supplied hardware and washers.
Steps to adjust overhang for optimal tracking distortion and alignment using an alignment jig.
Guide on setting tracking force and azimuth using the tonearm and alignment tools.
Explanation of anti-skating and VPI's unique solution using the tonearm's coiled wire.
Procedure to set tonearm height by adjusting setscrews to achieve parallel arm tube to record surface.
Guidance on using damping fluid sparingly for pivot stabilization with specific cartridges or sound issues.
Advice on using shielded interconnects and connecting the ground lead to prevent hum.
Steps for playing records, including tightening arm base setscrews and using the record clamp.
Recommendations for break-in time, motor noise, and platter bearing lubrication.
To Next Page
