4
Unlock the packaging locks:
Rotate the packaging lock counter-clockwise
through 90 degrees
Pull out the packaging lock
INSTRUCTIONS
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the attachable panel. Use a coin or
a screwdriver to loosen the screw.
3. Install 2 new ‘AA’ (AM-3/LR6) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries
is re commende d f or maximu m
performance.)
4. Replace the battery cover and tighten
the screw to secure the battery cover.
BATTERY NOTICE
• The use of new alkaline batteries is recommended for maximum
performance.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being
charged (if removable).
Instructions
To Next Page
Loading...
Need help?
General
