EN - 23
English
Appendix
FCC, ACTA and IC regulations
FCC Part 15
This equipment has been tested and found
to comply with the requirements for a Class
B digital device under Part 15 of the Federal
Communications Commission (FCC) rules.
These requirements are intended to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this equipment not
expressly approved by the party responsible
for compliance could void the user’s authority
to operate the equipment.
This device complies with Part 15 of the FCC
rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
This Class B digital apparatus complies with
Canadian ICES-003.
FCC Part 68 and ACTA
This equipment complies with Part 68 of the
FCC rules and with technical requirements
adopted by the Administrative Council for
Terminal Attachments (ACTA). The label on the
back or bottom of this equipment contains,
among other things, a product identifier in the
format US:AAAKXNANXXXX. This identifier must
be provided to your telephone service provider
upon request.
The plug and jack used to connect this
equipment to premises wiring and the
telephone network must comply with applicable
Part 68 rules and technical requirements
adopted by ACTA. A compliant telephone cord
and modular plug is provided with this product.
It is designed to be connected to a compatible
modular jack that is also compliant. An RJ11
jack should normally be used for connecting to
a single line. See the installation instructions in
the user’s manual.
The Ringer Equivalence Number (REN) is
used to determine how many devices you
may connect to your telephone line and still
have them ring when you are called. The
REN for this product is encoded as the 6th
and 7th characters following the US: in the
product identifier (e.g., if ## is 03, the REN is
0.3). In most, but not all areas, the sum of all
RENs should be five (5.0) or less. For more
information, please contact your telephone
service provider.
This equipment may not be used with Party
Lines. If you have specially wired alarm dialing
equipment connected to your telephone line,
ensure the connection of this equipment does
not disable your alarm equipment. If you
have questions about what will disable alarm
equipment, consult your telephone service
provider or a qualified installer.
If this equipment is malfunctioning, it must be
unplugged from the modular jack until the
problem has been corrected.
To Next Page
Loading...
Need help?
General
