VTech BM5200N - Monitoring Modes; Single CAM, Split, and Patrol Modes

30
Monitoring Modes (BM5200N-2 only)
When more than one baby unit is paired to the parent unit, you can choose to view
di󰀨erent baby units in three monitoring modes. Learn more about each below:
Single Mode The screen displays images only from the selected
baby unit in full screen.
Split Mode The screen displays images from all paired baby
units at the same time in split view.
Patrol Mode The screen displays a single cam view that
transitions to a di󰀨erent baby unit every 10
seconds.
Status check - Two baby units
If you are viewing baby unit , the POWER LED light of baby unit turns
on. As baby unit is not being viewed, its POWER LED light ashes.
Notes:
• If you power on only one baby unit, you may see the parent unit displaying
and then , and the LINK LED light ashing.
• Press VIEW in Single CAM or Patrol mode to switch to the baby unit you have
powered on.