32
General Product Care
To keep this product working well and looking good, follow these guidelines:
• Avoid putting it near heating appliances and devices that generate electrical noise (for
example, motors or uorescent lamps).
• DO NOT expose it to direct sunlight or moisture.
• Avoid dropping the product or treating it roughly.
• Clean with a soft cloth.
• DO NOT immerse the parent unit and the baby unit in water and do not clean them under the tap.
• DO NOT use cleaning spray or liquid cleaners.
• Make sure the parent unit and the baby unit are dry before you connect them to the mains again.
Storage
When you are not going to use the baby monitor for some time, store the parent
unit, the baby unit and the adapters in a cool and dry place.
Technical Specications
Frequency control Crystal controlled PLL synthesizer
Transmit frequency Baby unit: 2405-2475 MHz
Parent unit: 2405-2475 MHz
Maximum power used by the transmitter: 0.1W (100mW)
Channels 32
LCD 5” Colour LCD
(WQVGA 480x272 pixel)
Nominal eective range Actual operating range may vary according to environmental
conditions at the time of use.
Power requirement Parent unit: 3.6V, 2600mAh, 9.36Wh Li-ion battery
Baby unit power adapter: Output: 6V DC @ 400mAh
Parent unit power adapter: Output: 5V DC @ 1A
Credits:
The Background Noise sound le was created by Caroline Ford, and is used under the Creative Commons license.
The Stream Noise sound le was created by Caroline Ford, and is used under the Creative Commons license.
The Crickets At Night sound le was created by Mike Koenig, and is used under the Creative Commons license.
The Heart Beat sound le was created by Zarabadeu, and is used under the Creative Commons license.
To Next Page
Loading...
Need help?
General
