VTech Bubble Time Turtle User Manual

5
5
5
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back
of the unit. Use a screwdriver to
loosen the screw and then open the
battery cover.
3. If used batteries are present,
remove these batteries from the unit
by pulling up on one end of each
battery. Remove the third old battery
on the bottom by pulling up the strip
of cloth.
4. Install 3 new AA batteries following
the diagram inside the battery
box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommended
are to be used.
• Donotshort-circuitthesupplyterminals.

VTech Bubble Time Turtle Specifications

General

Brand	VTech
Model	Bubble Time Turtle
Category	Toy
Language	English