69
Answering system
Use the answering system menu of a cordless
handset to turn on or off the answering system
or message alert tone, set up the announcement
message, activate the call screening, or change the
number of rings, remote access code or message
recording time.
If your answering system is turned off and you change any of its
settings, the answering system automatically turns on again.
You may also turn on or off the answering system on the telephone base.
Announcement
The telephone is preset with a greeting that answers calls with,
“Hello. Please leave a message after the tone.” You can use this
preset announcement, or replace it with your own.
Record your own announcement
You can record an announcement up to 90 seconds, but any
announcement shorter than two seconds will not be recorded.
Press MENU when the handset is not in use.
Press or to scroll to Answering sys, then
press SELECT.
Press SELECT again to select Announcement.
Press SELECT again to select Record annc. The
system announces, “Record after the tone. Press 5
when you are done.” After the tone, speak towards
the microphone.
Press 5 when done. The answering system
automatically plays back the newly recorded
announcement, then returns to the previous menu.
-OR-
Press CANCEL to return to the previous menu.
1.
2.
3.
4.
5.
Answering system settings
Play messages
>Answering sys
>Announcement
Delete all old
>Record annc
Play annc
RECORDING ANNC...
5-Stop
To Next Page
Loading...
Need help?
General
