73
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You
can set the code from 00 to 99.
Press MENU when the handset is not in use.
Press or to scroll to Answering sys, then
press SELECT.
Press or to scroll to Ans sys setup, then
press SELECT.
Press or to scroll to Remote code, then
press SELECT.
Press or to move the cursor to the left
or right. Use the dialing keys (0-9) to enter a
two-digit number.
Press SELECT. You hear a confirmation tone.
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. The message
alert tone is preset to Off.
There is no audible alert at the handset.
Press MENU when the handset is not in use.
Press or to scroll to Answering sys, then
press SELECT.
Press or to scroll to Ans sys setup, then
press SELECT.
Press or to scroll to Msg alert tone, then press SELECT.
Press or to choose On or Off, then press SELECT. You hear a
confirmation tone.
The answering system must be turned on for the message alert tone
feature to be functional.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
# of rings
>Remote code
REMOTE CODE
19
MSG ALERT TONE
>Off
To Next Page
Loading...
Need help?
General
