VTech CS2050 Series User Manual

38
Register a handset
When your handset is deregistered from
the telephone base, follow the steps
below to register it back to the telephone
base.
1. Remove the handset from the
telephone base.
2. Press when the phone is not in
use.
3. Press ▼/▲ to choose REGISTRATION,
and then press to select. There
are 4 bases to choose from- optional
for supporting multiple bases.
• BASE 1
X
(by default)
• BASE 2
• BASE 3
• BASE 4
4. Press ▼/▲ to choose the base to
register. Then, press to confirm.
• PIN? - - - - displays; - - - - cursor
flashes.
5. Enter the 4-digit system PIN, and
press . (Default: 0000)
Press and hold at the telephone
base for about five seconds until IN
USE light turns on.
• PLEASE WAIT displays.
• REGISTER! displays if the handset
did not find and register to the
base sucessfully.
• If handset is registered to the base
sucessfully, the base will assign
next available handset number to
the handset automatically.
• You hear a beep when the
registration process completes.
• The registration process takes
about 60 seconds complete.
NOTE
• If your handset is new, make sure
you charge it before attempting
registration.
Reset phone settings
You can reset your phone to the default
settings. After reset, all settings and
entries (except phonebook, call list, and
redial list) will be deleted.
1. Press when the phone is not in
use.
2. Press ▼/▲ to choose DEFAULT, and
then press to select.
• PIN? - - - - displays; - - - - cursor
flashes.
3. Enter the 4-digit system PIN, and
press . (Default: 0000)
4. Press to confirm.

VTech CS2050 Series Specifications

General

Brand	VTech
Model	CS2050 Series
Category	Telephone
Language	English