VTech CS6124-11 - Multiple Handset Use; Chain Dialing

13
Telephone operation
Chain dialing
Use this feature to initiate a dialing sequence from numbers stored in the
directory, call log or redial while you are on a call. Chain dialing can be useful
if you wish to access other numbers (such as bank account numbers or access
codes) from the directory, call log or redial list.
To access a number in the directory while on a call:
Press MENU/SELECT twice to select Directory.
Press CID or to scroll to the desired entry.
Press MENU/SELECT to dial the displayed number.
To access a number in the call log while on a call:
Press MENU/SELECT and then press CID or to select Call log.
Press MENU/SELECT and then press CID or to scroll to the
desired entry.
Press MENU/SELECT to dial the displayed number.
To access a number in the redial list while on a call:
Press REDIAL/PAUSE.
Press CID, or REDIAL/PAUSE repeatedly to browse to the
desired entry.
Press MENU/SELECT to dial the displayed number.
1.
2.
3.
1.
2.
3.
1.
2.
3.
You cannot edit a directory entry while on a call. For more details about the
directory, see page 14.
You cannot copy a call log entry into the directory while on a call. For more
details about the call log, see page 18.
You cannot erase a redial entry while on a call. For more details about the
redial memory, see page 14.
Press OFF/CANCEL to exit the directory, call log or redial list when you are on
a call.
•
•
•
•
Multiple handset use (for multi-handset models only)
You can use both handsets at the same time on an outside call.
To share an outside call:
When a handset is already on a call and you would like to join the call, press
/FLASH on the other handset to join the call.
To end the call, press OFF/CANCEL or place the handset in the telephone
base or charger. The call continues until all handsets hang up.
•
•