16
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can set
the code from 00 to 99.
Press MENU/SELECT when the handset is not in use.
Press VOL/ or VOL/CID to select
>
ANSWERING SYS, then press
MENU/SELECT.
Press VOL/ or VOL/CID to select
>
ANS SYS SETUP, then press
MENU/SELECT.
Press VOL/ or VOL/CID to select
>
REMOTE CODE, then press
MENU/SELECT.
Press the dialing keys (0-9) to enter the code or VOL/ or VOL/CID to
select from 00 to 99, then press MENU/SELECT to conrm.
Message alert tone
This telephone can beep every 10 seconds to alert you of new messages.
The tone stops when all new messages have been reviewed.
Press MENU/SELECT when the handset is not in use.
Press VOL/ or VOL/CID to select
>
ANSWERING SYS, then press
MENU/SELECT.
Press VOL/ or VOL/CID to select
>
ANS SYS SETUP, then press
MENU/SELECT.
Press VOL/ or VOL/CID to select
>
MSG ALERT TONE, then press
MENU/SELECT.
Press VOL/ or VOL/CID to choose ON or OFF, then press
MENU/SELECT to conrm your selection.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
The answering system must be turned on for the message alert tone
to function.
Press any key on the telephone base (except /FIND HANDSET) to temporarily
silence the message alert tone.
•
•
To Next Page
Loading...
Need help?
General
