VTech CS6419 User Manual

3
Getting started
Battery installation
Install the battery as shown below.
Plug the battery connector securely into the socket inside the handset
battery compartment.
Place the battery with the label THIS SIDE UP facing up and the wires inside
the battery compartment.
Align the cover flat against the battery compartment, then slide it towards the
center of the handset until it clicks into place.
Charge the handset by placing it in the telephone base or charger. The
CHARGE light is on when the handset is charging.
1.
2.
3.
4.
If the handset will not be used for a long time, disconnect and remove the
battery to prevent possible leakage.
To purchase replacement batteries, visit our website at
www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to
www.vtechcanada.com or dial 1 (800) 267-7377.
•
•
1
CHARGE light
remains on when
charging.
2
3
4

VTech CS6419 Specifications

Frequency and Channels

transmit frequency handset	1921.536-1928.448 MHz
transmit frequency telephone base	1921.536-1928.448 MHz
channels	5

Power Requirements

handset battery voltage	2.4V Ni-MH
telephone base power	6V AC @ 300mA
charger power	6V AC @ 300mA

Memory

handset directory memory locations	50
handset directory digits capacity	30 digits
handset directory characters capacity	15 characters