VTech CS6419 User Manual

4
Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table below).
For best performance, keep the handset in the telephone base or charger when
not in use.
The battery is fully charged after 10 hours of continuous charging.
If you place the handset in the telephone base or the charger without plugging
in the battery, the screen displays NO BATTERY.
•
•
•
Battery indicators Battery status Action
The screen is blank,
or displays PLACE IN
CHARGER and flashes.
Battery has no or
very little charge. The
handset cannot be used.
Charge without interruption
(about 30 minutes).
The screen displays
LOW BATTERY and
flashes.
Battery has enough
charge to be used for a
short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
When the battery is fully charged, you can expect the following performance:
Operation Operating time
While in handset use (talking*) Up to seven hours
While in speakerphone mode (talking*) Up to four hours
While not in use (standby**) Up to five days
*Operating times vary depending on your actual use and the age of the battery.
**Handset is not charging or in use.
After you install your telephone or power returns following
a power outage, the handset will prompt you to set the date
and time. For instructions, see Set date and time on page
13. To skip setting the date and time, press OFF/CANCEL.
SET DATE
--/--/--

VTech CS6419 Specifications

Frequency and Channels

transmit frequency handset	1921.536-1928.448 MHz
transmit frequency telephone base	1921.536-1928.448 MHz
channels	5

Power Requirements

handset battery voltage	2.4V Ni-MH
telephone base power	6V AC @ 300mA
charger power	6V AC @ 300mA

Memory

handset directory memory locations	50
handset directory digits capacity	30 digits
handset directory characters capacity	15 characters