42
Deregister handets
If you want to replace a handset, or reassign the designated handset number of
a registered handset, you must deregister all handsets that are registered to the
telephone base. Then register each handset individually.
If you want to register a handset to another compatible base (CS6619/CS6629/
CS6648/CS6649), you must deregister all handsets and then register each handset
individually to the desired telephone base.
To make deregistration easier, read all of the instructions below before you begin.
To deregister all handsets:
Press and hold /FIND HANDSET on the telephone base for about 10 seconds until
the IN USE light on the telephone base turns on and starts to ash.
Immediately press /FIND HANDSET again. You must press /FIND HANDSET
while the IN USE light is still ashing. The IN USE light ashes for approximately
ve seconds.
All handsets display To register HS and See manual alternately when the
deregistration process completes. The deregistration process takes about
10 seconds to complete.
To register the handset(s) to the telephone base again, follow the registration
instructions on the previous page.
You cannot deregister all handsets if any other system handset is in use.
If deregistration fails, you may need to reset the system and try again. To reset, unplug
the power from the telephone base and plug it back in.
Even if the battery is depleted, you can still deregister all handsets by following the steps
above. After the handset is charged for at least 10 minutes, the handset alternately
shows To register HS and See manual.
1.
2.
3.
•
•
•
42
Appendix
To Next Page
Loading...
Need help?
General
Weight and Dimensions
