EasyManuals Logo

VTech CS6649-2 User Manual

VTech CS6649-2
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
Appendix
57
The cordless handsets provided with your telephone system are already registered as
HANDSET 1 and so forth. Additional handsets registered to the telephone system are
assigned numbers in the sequential order. This telephone system accommodates up
to ve handsets.
You can add new handsets (CS6609, purchased separately) to your telephone
system. Each handset must be registered with the telephone base before use. When
rst purchased and properly charged, each expansion handset displays
To register HS and See manual alternately. You may need to charge the handset
before registering it to the telephone base. For more information on battery charging,
see the table on page 4.
Add and register a handset
When rst purchased, each expansion handset alternately shows
To register HS and See manual. The new handset should
be charged without interruption for at least 30 minutes before
registering it to the telephone base.
Make sure the handset is out of the handset charger and is put
near the telephone base. Make sure the handset alternately
shows To register HS and See manual before you begin
registration.
To register a handset:
Press and hold FIND HANDSET on the telephone base for
about four seconds until the IN USE light turns on and it
shows Registering...
Press QUIET
#
on the handset. The handset shows
Registering... Both the telephone base and cordless handset
show Registered, and you hear a beep from the handset
when the registration process completes. The registration
process takes about 60 seconds.
If registration fails, the handset displays Failed. Try again the
registration process above.
You cannot register a handset if any other system handset is
in use.
If you have not set the date and time for the telephone system,
the handset will prompt you to set the date and time after it is
registered to the base. To skip setting, press CANCEL.
You can only register one handset to the telephone base at a time.
1.
2.
Expand your telephone system
Appendix
Before registration,
make sure the handset
is not in the charger.

Table of Contents

Other manuals for VTech CS6649-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VTech CS6649-2 and is the answer not in the manual?

VTech CS6649-2 Specifications

General IconGeneral
BrandVTech
ModelCS6649-2
CategoryCordless Telephone
LanguageEnglish

Related product manuals