26
I cannot dial
out.
Make sure there is a dial
tone before dialing. It
is normal if the handset
takes a second or two
to synchronize with the
telephone base before
producing a dial tone. Wait
an extra second before
dialing.
Eliminate any background
noise. Mute the handset
before dialing, or dial from
another room in your home
with less background
noise.
The display
shows To
register
HS... and
...see manual
alternately.
The handset
does not work
at all.
The handset is
deregistered from the
telephone base.
Place the handset in the
telephone base to register
it back. The handset shows
Registered and you hear a
beep when the registration
process completes. This
process takes about 90
seconds to complete.
The display
shows Low
battery.
Place the handset in the
telephone base or charger
for charging.
The battery
does not
charge in the
handset or
the handset
battery does
not accept
charge.
Make sure the handset is
placed in the telephone
base or charger correctly.
If the battery is completely
depleted, charge the
battery for at least 30
minutes before use.
You may need to purchase
a new battery.
The telephone
does not ring
when there is
an incoming
call.
Make sure the ringer volume
is not set to off.
The handset may be too
far from the telephone
base. Move it closer to the
telephone base.
My handset
beeps
and is not
performing
normally.
Move the handset closer to
the telephone base. It may
be out of range.
I hear other
calls when
using the
telephone.
Disconnect the telephone
base from the telephone
wall jack. Plug in a different
telephone. If you still hear
other calls, the problem is
probably in the wiring or
telephone service. Contact
your telephone service
provider.
I hear noise on
the cordless
handset and
the keys do
not work.
Make sure the telephone
line cord is plugged in
securely.
To Next Page
Loading...
