Set date and time
The answering system announces the date and time of each message prior to
playing it. Before using the answering system, set the date and time as follows. If you
subscribe to caller ID service, the day, month and time are set automatically with each
incoming call. However, the year must be correct so that the day of the week can be
calculated from the caller ID information.
Press MENU when the handset is not in use.
Press or until the handset displays Set date/time,
then press SELECT.
Press or to select the month then press SELECT,
or use the dialing keys to enter a two-digit number (01-12).
Press or to select the date then press SELECT,
or use the dialing keys to enter a two-digit number (01-31).
Press or to select the year then press SELECT,
or use the dialing keys to enter a two-digit number (00-99) then
press SELECT.
Press or to select the hour then press SELECT,
or use the dialing keys to enter a two-digit number (01-12).
Press or to select the minute then press SELECT,
or use the dialing keys to enter a two-digit number (00-59).
Press or to select AM or PM.
Press SELECT to save the settings. You hear a confirmation tone.
If the date and time are not set when a message is recorded, the system announces,
“Time and date not set,” before each message plays.
The phone plays two beeps if you enter an invalid number.
1.
2.
3.
4.
5.
6.
7.
8.
9.
•
•
Set date/time
ECO
Date: MM/DD/YY
ECO
Time: HH:MM --
ECO
To Next Page
Need help?
General
Weight and Dimensions
