EN - 24
Question Suggestion
The cordless handset beeps and is not
performing normally.
• Make sure the power cord is securely
plugged into the telephone base. Plug the
telephone base into a different working
electrical outlet not controlled by a wall
switch.
• Move the cordless handset closer to the
telephone base or adjust the setting of RF
transmission power (page 35). It may be out
of range.
• Reset the telephone base by unplugging
the electrical power to the base. Wait for 15
seconds and plug it back in again. Allow up
to one minute for the cordless handset and
the telephone base to synchronize.
• Other electronic products such as HAM
radios and other DECT phones can cause
interference with the cordless phone. Try
installing the phone as far away as possible
from these types of electronic devices.
To Next Page
Loading...
Need help?
General
