EN - 13
English
Set up
Near Term Cordless 1-line - CTM-A2415
Program phone settings
In order to program different telephone settings, you have to enter ADMIN mode during system
idle by pressing *7764#MUTE on the handset.
• During ADMIN mode, MUTE key LED on handset, the MESSAGE WAITING LED and SPEAKER
LED on the base will blink.
To quit ADMIN mode with your settings, press OFF key, and you will hear 2 rising beeps to
confirm. To quit ADMIN mode without saving your settings, press OFF key before MUTE key.
Phone settings
Default settings are indicated by asterisks (*).
Some settings have their corresponding Access Keys or Access Codes. After entering the setting
value, press MUTE to confirm. You will hear a confirmation tone. Set another setting after previous
setting is saved.
Setting Access code/ key Options Adjustable by
Listening volume- Handset 1, 2, 3, 4*, 5, 6
User and
administrator
Speakerphone volume -
Handset
1, 2, 3, 4*, 5, 6
User and
administrator
Speakerphone volume -
telephone base
1, 2, 3, 4*, 5, 6
User and
administrator
Ringer volume - telephone
base
1, 2*, 3
User and
administrator
Ringer tone 00 Tone 1*, Tone 2, Tone 3 Adminstrator only
Flash FLASH
1 (100ms), 2 (300ms), 3*
(600ms)
Adminstrator only
RF transmission power -
telephone base
01
1 (low), 2* (middle), 3
(high)
Adminstrator only
Voicemail voltage detection
• Steady high voltage,
periodic high voltage pulse
and periodic low voltage
pulse detection method
• Line reversal method
• FSK detection method
• Panasonic
• 10
• 11 (Line rev.)
• 12 (FSK)
• 14 (Panasonic)
0 (disable), 1 (enable) Adminstrator only
Voicemail voltage detection
• Siemens
13
0 (disable), 1 (50Hz), 2
(25Hz), 3 (20Hz)
Adminstrator only
To Next Page
Loading...
Need help?
General
