EN - 18
Find handset
Use this feature to find all registered
cordless handsets.
Start paging
Press FIND HS (FIND HANDSET) on the
telephone base when the telephone is not
in use. All idle cordless handsets beep for 60
seconds.
End paging
• Press FIND HS (FIND HANDSET) again on the
telephone base; or
• Press any key on the cordless handset to
stop the paging tone.
Data port
You can connect your modem or fax
machine to the telephone line through the
DATA port.
Appendix
Handset battery
It takes up to 12 hours for the battery to be
fully charged. When it is fully charged, you can
expect the following performance:
Operation Operating time
While in handset use
(talking*)
Up to 7 hours
While in
speakerphone mode
(talking*)
Up to 5 hours
While not in use
(standby**)
Up to 7 days
* Operating times vary depending on your
actual use and the age of the battery.
** Handset is not charging or in use.
The battery needs charging when:
• A new battery is installed in the handset.
• LOW BATTERY LED illuminates on the
cordless handset.
To reduce the risk of fire or injury, read and
follow these instructions:
• Use only the supplied rechargeable battery
(BT164392/BT264392) or replacement battery
(BT266342). To order a replacement, contact
your local distributor.
• Do not dispose of the battery in a fire. Check
with local waste management codes for
special disposal instructions.
• Do not open or mutilate the battery.
Released electrolyte is corrosive and may
cause burns or injury to the eyes or skin. The
electrolyte may be toxic if swallowed.
• Exercise care in handling the battery in order
not to create a short circuit with conductive
materials.
• Charge the battery provided with or
identified for use with this product only
in accordance with the instructions and
limitations specified in this user guide.
To Next Page
Loading...
Need help?
General
