BATTERY INSTALLATION
Note: Adult assembly is required for battery installation.
1. Make sure the unit is turned OFF.
2. Locate the battery compartment on the bottom of the chalkboard. Use a screwdriver to open the battery cover.
3. Remove the exhausted batteries and install 4 new AA batteries as illustrated.
4. Replace the battery cover and tighten the screws. Do not over-tighten the screws.
BATTERY NOTICE
Use new alkaline batteries or fully charged NI-MH (Nickel Metalhydride) rechargeable batteries for best
performance.
Use only batteries of the same or equivalent type as recommended.
Do not mix different types of batteries: alkaline, standard (carbonzinc) or rechargeable, or new and used
batteries.
Do not use damaged batteries.
Insert batteries with the correct polarity.
Do not short-circuit the battery terminals.
Remove exhausted batteries from the toy.
Remove batteries during long periods of non-use.
Do not dispose of batteries in fire.
Do not charge non-rechargeable batteries.
Remove rechargeable batteries from the toy before charging (if removable).
Rechargeable batteries are only to be charged under adult supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain substances that can be damaging to the environment and
human health. The chemical symbols Hg, Cd or Pb, where marked, indicate that the battery contains more than the
specified value of mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
To Next Page
Loading...
Need help?
General