VTech Disney Frozen II Magic Learning Watch - Using the VTech Frozen II Magic Learning Watch; Automatic Power Off

7
7
7
TO BEGIN USING THE VTECH
®
FROZEN II MAGIC LEARNING WATCH
When you use the watch for the rst time, open the cover, then press the
LEFT+RIGHT+OK Buttons for approximately 5 seconds to unlock the
Try Me mode. You will hear three ‘beeping’ sounds when the try me mode
is unlocked. You can then press any button to activate the watch and set the
time.
Press the Left or Right Button to select, then press the OK Button to
conrm and move to the next option. A tick will be displayed when the
setting is complete.
Note:
• When the battery level is low, most functions on the watch may not be
activated, except for the clock display. It is recommended to change to
a new battery as soon as possible before further use.
• If the battery level is too low and cannot keep the clock running, you
will need to enter the time again after the battery has been replaced.
AUTOMATIC POWER OFF
To save power, the VTech
®
Frozen II Magic Learning Watch will
automatically power off when there has been no input for about 30 seconds.
Press any button or open the cover to turn the unit ON again.
Note: The VTech
®
Frozen II Magic Learning Watch will not
automatically power off when the Stopwatch is running.
The unit will also automatically turn OFF when the battery
power is very low. If you see the Low Battery icon appear
on screen, please replace the battery.