Appendix
76
Move the cordless handset closer to the telephone base. You may have moved
out of range.
Reset the telephone base. Unplug the electrical power. Wait for 15 seconds then
plug it back in. Allow up to one minute for the cordless handset and telephone
base to reset.
Other electronic products such as HAM radios and other DECT phones can
cause interference with your cordless phone. Try installing your phone as far
away as possible from these types of electronic devices.
The battery does not charge in the handset, or the handset battery does not
accept charge.
If the cordless handset is in the telephone base or handset charger and the
charge light is not on, refer to The charge light is off (page 78).
Charge the battery in the cordless handset for at least 12 hours. For optimum
daily performance, return the cordless handset to the handset charger when not
in use.
If the battery is completely depleted, charge the handset for at least 30 minutes
before use (page 4).
You may need to purchase a new battery. Please refer to Handset battery
installation (page 3) and Handset battery charging (page 4).
I get noise, static, or weak signals even when I’m near the telephone base.
If you subscribe to high-speed Internet service (DSL - digital subscriber line)
through your telephone line, you must install a DSL filter between the telephone
line cord and the telephone wall jack (page 2). The filter prevents noise and
caller ID problems as a result of DSL interference. Please contact your DSL
service provider for more information about DSL filters.
You may be able to improve the performance of your cordless phone by installing
your new telephone base as far as possible from any other existing cordless
telephone system that may already be installed.
Other electronic products such as HAM radios and other DECT phones can
cause interference with your cordless phone. Try installing your phone as far
away as possible from these types of electronic devices.
Do not install this phone near a microwave oven or on the same electrical
outlet. You may experience decreased performance while the microwave oven
is operating.
If you plug your phone in with a modem or a surge protector, plug the phone
(or modem/surge protector) into a different location. If this does not solve the
problem, relocate your phone or modem farther apart from one another, or use a
different surge protector.
•
•
•
•
•
•
•
•
•
•
•
•
Troubleshooting
To Next Page
Loading...
Need help?
General
Weight and Dimensions
