VTech EzRay Air Portable - Waiting Time Setting for the Sleep Mode 1

5. Service Mode
56 EzRay Air Portable (Model: VEX-P300) User Manual
5.3.6 Waiting Time Setting for the Sleep Mode 1
Follow the procedure below to set up the waiting time for Sleep Mode 1.
Service Mode No. Item
n.19 Waiting time setting for the Sleep Mode 1
To change the waiting time for Sleep Mode 1
1. Select n.19 and press the jog dial. The default time “001” (1 minute) is displayed
on the control panel, as shown in the right figure.
2. Turn the jog dial to the right to change the time (The selection is available from 1
to 999 minutes).
3. Press the dial again until you hear a beep.
4. Restart the device to check if the new setting is saved correctly.