Appendix
78 EzRay Air Portable (Model: VEX-P300) User Manual
2. Remove each cross-head screw using a screwdriver to separate the upper part from
the bottom part.
Ensure to keep all screws securely until the end of the
procedure.
3. Attach the Base Holder’s bottom part to the Tripod’s baseplate.
4. Put the device on the holder’s bottom part and place the upper part over the device
(See below). Insert each cross-head screw into a hole and tighten it with a
screwdriver.
Ensure that the Base holder’s bottom part is securely
attached to the Tripod’s base plate before connecting the
upper part.
Ensure to hold the device to avoid a fall while connecting the
Base Holder’s upper part.
To Next Page
Loading...