VTech Genius Notebook - GETTING STARTED; POWER SOURCE; BATTERY INSTALLATION; STANDARD FOR BATTERY TOYS

LM
GETTING STARTED
3
GETTING STARTED
POWER SOURCE
The Genius Notebook operates on 3 “AA” size batteries (UM-
3/LR6) or a VTech
®
9V adaptor (sold separately).
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery covers on the bottom of
the unit and open them.
3. Insert 3 new “AA” batteries (UM-3/LR6)
as illustrated.
RECHARGEABLE BATTERIES ARE NOT
RECOMMENDED.
4. Close the battery covers.
NOTE: For best performance, remove all
factory-installed batteries and use new, alkaline batteries.
STANDARD FOR BATTERY TOYS
• Do not try to recharge non-rechargeable batteries;
• Rechargeable batteries are to be removed from the toy before
being charged;
• Rechargeable batteries are only to be charged under adult
supervision;
• Do not mix different types of batteries; Do not mix new and
used batteries;
• Only use batteries of the recommended or equivalent type;
• Always insert batteries properly matching the plus (+) and minus
(-) signs;
• Batteries that have run out of energy must be removed from
the toy;
• Do not short-circuit the supply terminals;
• Do not use more batteries than recommended;
• Do not mix alkaline, standard(carbon-zinc) or rechargeable
(nickel-cadmium) batteries
• Remove batteries from the toy if it will not be used for an
extended period of time.
64900 new-2 copy 5/18/05, 16:082