VTech gz 2434 - Handset Features; Volume and Channel Control; Call Management Functions; Programming and Dialing

6
Handset Features
SELECT
·Press to select a displayed
function; press to confirm
a programming operation.
OFF
·Press this key to end a
call. The OFF key is also
used to exit all modes
of operation.
PROGRAM
·This key is used to enter
Programming mode.
REDIAL/PAUSE
·Press PHONE, then
press REDIAL/PAUSE
to call last number
dialed (up 32 digits)
-OR-
Press REDIAL/PAUSE,
then press PHONE to
call last number dialed.
In the idle mode, press
REDIAL/PAUSE twice
to delete the last number
dialed.
Volume Keys
· While on a call, press
to raise or to lower
the volume. A double
beep will sound then you
reach maximum or
minimum level.
PHONE/FLASH
· Press PHONE/FLASH
then dial the number to
make a call.
· Dial the number (use
to backspace and correct
digits), then press
PHONE/FLASH to make
a call.
· While on a call, when
you receive a Call Waiting
alert, press PHONE/FLASH
to switch between calls.
· Press PHONE/FLASH
or any key except OFF
to answer a call.
HOLD
· Press this key to put a
call on hold, press again
to release hold.
CHANNEL
· If you experience noise
or interference while on
a call, press CHAN to
switch to clear channel.