VTech ia5847 - There is noise or interference during a telephone conversation.; My calls fade out or cut in and out when I am using the cordless handset.

www.vtechphones.com
33
Additional information
Troubleshooting
Problem Suggestion
The CHARGE/IN
USE Indicator on the
telephone base is
ashing
• This is a signal that the battery is very low, completely depleted, or when there is no electrical
contact between the battery and the telephone base.
• Ensure the connector of the battery is securely plugged into the handset and place the handset
in the telephone base for charging.
There is no dial tone. • First, try all the above suggestions.
• Move the cordless handset closer to the telephone base. It might be out of range.
• The telephone line cord might be malfunctioning. Try installing a new telephone line cord.
• Disconnect the telephone base from the telephone jack and connect a different telephone.
If there is no dial tone on the telephone either, the problem is in your wiring or local service.
Contact your local telephone company.