15
15
Memory Card Installation
The KidiZoom
®
PrintCam camera
is compatible with microSD and
microSDHC memory cards up to 32 GB.
To install:
• Make sure the camera is Off.
• Open the cover over the Memory
Card Slot on the side of the camera.
• Insert a memory card (not included) as illustrated. Once the
memory card is detected, the memory card will automatically be
used as the default memory.
• To remove the memory card from the camera, push the card once
and it will eject.
Note
• VTech
®
recommends that you format your memory card before using
it with the KidiZoom
®
PrintCam camera.
• Data stored on the camera’s internal memory will not be accessible
while the memory card is in use. Be sure to back up all data to a
computer regularly to prevent loss of photos and video.
Frequency is set correctly in the camera’s Settings menu. (See the
Settings section in this Parent’s Guide). Avoid having a direct light
source pointing towards the camera.
TO BEGIN USING KIDIZOOM
®
PRINTCAM
Make sure the Master Power Switch is in the
position and charge
the camera before using.
Press the Home/On/Off Button
to turn the camera On. When
turning the camera On for the rst time, you will be asked to select the
language and set the date and time.
Note: If the battery level is too low and cannot keep the clock running,
enter the time and date again after recharging. If you wish to later
change the language, date or time, you can do so from the Settings
menu.
To Next Page
Loading...
