VTech My Busy Workbench - Power Tool Assembly Instructions

16
16
16
POWER TOOL ASSEMBLY INSTRUCTIONS
Circular Saw, Drill Press and Sander
1. Insert the Drill Press Top into the
Drill Press Base. You will hear the
pieces snap into place when properly
inserted.
2. Insert the Circular Saw Top into the
Circular Saw Base. You will hear the
pieces snap into place when properly
inserted.
3. Insert the Sander Top into the Sander
Base. You will hear the pieces snap
into place when properly inserted.
NOTE: The tool tops and bases cannot be disassembled after
assembly.