33
Night Vision
The baby unit has infrared LEDs that allow you to see your baby clearly at night
or in a dark room. When the baby unit being viewed detects low light levels, the
infrared LEDs switch on automatically.
When the night vision mode is activated, the images from the baby unit appear in
black and white on the screen, and also appears.
Notes:
• It is normal to see a short white glare on your parent unit screen as the baby unit adapts to
the dark environment.
• If you adjust the night vision mode while night vision is not activated, the new settings will be
saved and applied the next time it activates.
Tip: The video quality may vary depending on the surrounding environment and interfering
factors like lighting, objects, colour and backgrounds. Adjust the baby unit angle or place the
baby unit at a higher elevation to prevent glare and a blurry display.
Adjust Baby Unit Speaker Volume
1� Press to enter the main menu.
2� Press repeatedly to choose General Settings menu.
3� Press , then press repeatedly and select Volume.
4� P
ress
or
to adjust (1 bar - Lowest to 5 bars - Highest).
Temperature format
1� Press to enter the main menu.
2� Press repeatedly to choose General Settings menu.
3� Press , then press repeatedly and select temperature format.
4� P
ress
or
to adjust °C or °F.
Software and Firmware Update
To ensure that your baby monitor is always at its best performance, the parent unit
will prompt you to update its software and the baby unit rmware when there are
new versions available.
You can check if your device is running on the latest software:
1� Press to enter the main menu.
2� Press repeatedly to select General Settings.
3� Press , then press repeatedly and select Help information.
To Next Page
Loading...
