VTech Spin Master Nickelodeon Paw Patrol Learning Pup Watch - Getting Started and Basic Operation; Battery Replacement Procedure

5
5
5
devotreenfantnesoitnitropserré,nitroplâche.Sivousobservez
des rougeurs, gonflements ou autre irritation, veuillez consulter un
médecin avant de remettre la montre.
GETTING STARTED
Battery Removal and Installation
NOTE: For best performance, remove the
factory-installed battery from the Learning Pup
Watch and use a new battery.
1. Make sure the watch cover is closed.
2. Findthebatterycoverlocatedontheback
of the unit, use a screwdriver to loosen the
screw and then open the battery cover.
3. Use the screwdriver to push the metal piece
according to the diagram. Remove the battery
when one end of the battery pops up.
4. Followthediagraminsidethebatteryboxto
installonenewCR2450battery,pressitinto
the battery room.
5. Replacethe battery coverand tighten the
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.