VTech Spin Master Nickelodeon Paw Patrol Learning Pup Watch - Initial Setup and Time Setting

7
7
7
are to be used.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use.
• Removeexhaustedbatteriesfromthetoy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinfire.
RECHARGEABLE BATTERIES:
• Removerechargeablebatteries(ifremovable)fromtoybefore
charging.
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.
• Donotchargenon-rechargeablebatteries.
TO BEGIN USING
When you use the watch for the first time,
you must unlock it from Try-Me mode to
play. To unlock from Try-Me mode, open
the Cover, and press the Left + Right +
OK Buttons together for approximately five
seconds. You will then hear three beeping
sounds to indicate it has been unlocked.
Press any button to activate the watch and
set the time.
Press the Left or Right Buttons to select, then press the OK
Button to confirm and move to the next option. A checkmark will be
displayed when the setting is complete.
Note
• When the battery level is low, most functions on the watch may
not be activated, except for the clock display. It is recommended
to install a new battery as soon as possible before further use.
• Ifthebatterylevelistoolowandcannotkeeptheclockrunning,
you will need to enter the time again after the battery has been
replaced.
Beep, beep,
beep!