VTech Toot-Toot Drivers Construction Site - Getting Started; Battery Installation - Digger; Battery Notice

5
GETTING STARTED
BATTERY INSTALLATION – DIGGER
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of
the digger. Use a screwdriver to loosen
the screw.
3. Install 2 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• UsenewalkalinebatteriesorfullychargedNI-MH(NickelMetal-
hydride) rechargeable batteries for best performance.
• AlkalineBatteriesarerecommended.
• AlkalineBatteriesarerecommended.Rechargeablebatteriesare
not guaranteed to work with this product.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used
batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
GETTING STARTED / BATTERY NOTICE